Injection equipment

Unicomponent pumps

  • 1K electric diaphragm pump (BM 1200)

    The compact, reliable and high-performance pump for professional use. The pump is equipped with the regulator for stepless change of pressure and giving.
  • 1K electric diaphragm pump (BM 1300)

    Compact, reliable and high-performance pump for professional use.
  • 1K electric piston pump (BM 0401)

    Compact and lightweight electric injection pump. Depending on the type of work and material, the pressure can vary from 0 to 400 bar and change with the help of increasing or decreasing the speed of the electric drill.
  • 1K electric piston pump (BM 0402)

    Compact and lightweight electric pump for injection work with an electric drill as a drive. Advantageously, it differs from competitors by the presence of an automatic pressure regulator, which does not allow the pressure to exceed the specified value.
  • 1K electric piston pump (BM 0440)

    Compact professional injection pump with smooth electronic pressure and flow control. Due to its small size it is suitable for use on forests and in hard-to-reach places.
  • 1K electric screw pump BMP 6 (BM 2697)

    Multifunctional and reliable pump for supplying cement-based injectable formulations, aqueous microemulsions of water-repellent agents, as well as gunning of cement slurries with a maximum particle size of up to 3 mm.
  • 1K hand pump (BM 0203/0205)

    Inexpensive and easy to handle entry level manual injection pump. It is intended for carrying out injection works in small volumes or on sites without electrical connection.
  • 1K hand pump (BM 0220)

    Simple and budget injection pump. Designed to supply cement injection compositions with a filler size of not more than 0.3 mm and aqueous microemulsions of water repellents. Suitable for small amounts of work and sites without electrical connection.
  • 1K pneumatic piston pump (BM 0433)

    High-performance professional pneumatic pump for supplying a wide range of injection composition and airless application of polymer coatings.
  • 1K the manual pump on a tripod (BM 0303/0304)

    Simple and low cost injection pump for injection compositions without abrasive particles. Suitable for small amounts of work and sites without electrical connection.

Two component pumps

  • 2K electric diaphragm pump (BM 1500)

    Pneumatic two-component pump with variable mixing ratio of components from 1: 1 to 1:15. The pump is designed to inject polyurethane gels.
  • 2K manual pump on a tripod (BM 0305)

    Simple and economical two-component injection pump for small amounts of work and sites without electrical connection.
  • 2K pneumatic piston pump (BM 1425 / BM 2515)

    Professional pneumatic 2k pump for injection of acrylate gels. The ratio of the components of the gel 1: 1. All elements of the pump in contact with the components of the gel are made of special stainless steel.